![]() ![]() Two sided end plate (142): Previously, an incorrect cut was created for the bottom flange notch when the secondary part was a C or U profile. Rebar hooks are now oriented correctly after splicing. Mesh bars: The orientation of rebar group hooks for single layer reinforcement has been fixed. Tapered I-beam (81): Previously, the width of the top flange was incorrectly applied in the component in some situations. Additionally, long side bars that are managed through multiple polygons are now connected linearly without any split or gap between them. Now, the minimum distance is handled based on the defined radius and rebar size. This setting cannot be used together with the Check top-in-form-face direction setting.īraced girder (88, 89): Previously, in some situations, side bars were not created because of the small distance between rebar points. Wall layout elementation tool now allows the elementation of cast-in-place (non-precast) layers.Įmbedded anchors (008): On the Input tab, you can now use the new Keep local direction setting to ensure that all anchors placed on opposite faces have the same Y axis always pointing to the main part of the assembly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |